Installation guide

5
General
This tab allows you to specify the network methods to be used with your Wireless LAN Card. The network policy
depends on your wireless network. For TCP/IP protocol, you should configure its properties as instructed by your
network administrator.
Wireless Networks
Under Available networks section, you can also see all the Access Points and Wireless LAN Cards (Ad-Hoc mode)
available in the air. Clicking Refresh will update the list of Access Points and Wireless LAN Cards (Ad-Hoc mode).
Under Preferred networks section, you can add any wireless networks that you wish to connect to. To do this, just
click Add and enter necessary network setting in Wireless Network Properties window and then click OK.
Authentication
The most important setting for the Wireless LAN Card is to disable Enable network access control using
IEEE802.1X to ensure successful connection between your Wireless LAN Card and Access Point or other wireless
client (Ad-Hoc mode). You must disable this function for any reason. Otherwise, there may be some problems
happening during connection. For other settings, we recommend you keep the default settings to minimize the
problems during connection.
Technical supportt t
Email:
[e-mail]
Web: www.airlinkplus.com
5