User guide

Configuration Commands
Rev 2.0 Jul.09 92
*NETOP?
Thecurrentcellularcarrierfromthemodemʹsfirmware
version,forexample,yourcellularprovided.
*NETRSSI?
ThecurrentRSSI(ReceiveSignalStrengthIndicator)ofthe
RavenXEasanegativedBmvalue.
Tip: The same information is displayed with the command S202?.
*NETSERV?
Thetypeofservicebeingusedbythemodem,forexample
Tech.
*NETSTATE?
Thecurrentnetworkstate:
• ConnectingToNetwork:TheRavenXE isintheprocessof
tryingtoconnecttothecellularnetwork.
• NetworkAuthenticationFail:Authenticationtothe
cellularnetworkhasfailed.Verifysettingstoactivatethe
RavenXE.
• DataConnectionFailed:TheRavenXEfailedtoconnect,
anditisnowwaitingasettimeintervalbeforeitattempts
toreconnect.VerifysettingstoactivatetheRavenXE.
• NetworkNegotiationFail:Networkconnectionnegoti‐
ationfailed.Thisisusuallytemporaryandoftenclearsup
duringasubsequentattempt.
• NetworkReady:TheRaven XEisconnectedtothe1x
cellularnetworkandreadytosenddata.
• NetworkDormant:TheRavenXEisconnectedtothe1x
cellularnetwork,butthelinkisdormant.Itwillbewoken
upwhendataissentorreceived.
• NoService:Thereisnocellularnetwork detected.
• HardwareReset:Theinternalmoduleisbeingreset.This
isatemporarystate.
*POWERIN?
Thevoltageinputtotheinternalhardwa re.
+ICCID
SubscriberIdentityModuleID..