Installation guide

Maintaining the Slate 33
Maintaining the Slate
Cleaning the Slate
Regularly clean your AirLiner WS100 wireless slate with a soft, damp cloth to remove dust and dirt
particles. If necessary, dampen the cloth using very mild soap that is diluted with water.
When you’re not using the slate and its tools, store them in a clean, dry place and avoid extremes
in temperature.
Don’t disassemble the slate or its tools. If you disassemble the slate or its tools, you’ll void your
warranty.
Don’t attempt to twist the pen open. It must remain a sealed unit to ensure proper performance.
Replacing the Pen Nib
The pen tip will wear with normal use. When the nib gets too short or develops a flat point, you can
replace it with another nib.
To order replacement parts, contact SMART Technical Support (page 43).
Replacing the Battery
All lithium polymer batteries typically need to be replaced every two or three years, whether they’re
used or not. If your battery has exceeded its life span and no longer recharges, contact SMART
Technical Support (page 43) to order a new one. Only order and use rechargeable lithium polymer
batteries that have been designed for the AirLiner WS100 wireless slate.
1. Turn the slate upside down and slide open the battery compartment door.
2. Carefully remove the old battery by disconnecting the battery’s plug from the socket.
CAUTION
Don’t clean the slate with volatile liquids such as paint thinner or benzene, as they
may damage the plastic case.
CAUTION
To maintain the sensitivity of your pen, don’t store the pen in a container where it
will rest on its tip.
WARNING
Never install other battery types in your slate, as this can cause damage to the
slate, and can cause a fire or personal injury.
To remove the battery