Installation guide

Customizing the Slate 29
The Configure Command Strip dialog box appears.
The Available Tools area on the left displays all of the icons that you can add to the tool strip.
NOTE: The available icons are displayed on four tabs called Display, Launch, General and
Tools.
The Current Toolbar area on the right displays the icons that are currently included in the tool
strip, and their order.
5. To add a tool from the Available Tools list, press the appropriate tab, highlight the required
icon, and press the Add>> button.
To add a link to an executable file, press Browse, navigate to and select the required file, and
press Open.
To add a link to a website, press Link to Website, enter the site’s Web address, and press
OK.
To remove a tool from the Current Toolbar list, select the tool and press the <<Remove button.
To rearrange the order of the tools in the tool strip, select the tool in the Current Toolbar list
and press the Move Up button or the Move Down button.
NOTE: The maximum number of tools for the tool strip is 11.
6. Close the SMART Board Settings and the SMART Board Control Panel dialog boxes.
The defined area of the tool strip is divided equally among its icons. For example, if you
customize the tool strip to have only two functions, you would press the top half of the tool strip
to activate one of the functions, and the bottom half to activate the other.