Installation guide

8 Installing the Slate
2. Plug the round end of the power adapter cable into the Power Connector port.
3. Connect the other end of the power adapter cable to an active power outlet.
4. The battery immediately begins to recharge whenever the power adapter cable is connected
and the battery isn’t fully charged. The battery recharges whether the slate is turned on or off.
The Charging indicator behaves as follows:
– If the indicator glows orange, the slate is connected to an external power source and the
battery is recharging.
– If the indicator glows green, the slate is connected to an external power source and the
battery is fully charged.
– If the indicator is off, the slate isn’t connected to an external power source. Check that the
power adapter cable is connected correctly to the slate and that the power outlet is
working. If the indicator still doesn’t glow, the battery can no longer hold sufficient charge
and must be replaced (page 33).
1. Press the SMART Board icon in the system tray (Windows® computers) or in the Dock
(Macintosh computers), and press Control Panel.
The SMART Board Control Panel dialog box appears.
2. Press SMART Board Settings.
The SMART Board Settings dialog box appears.
To check the battery’s charge
Charging Indicator