Installation guide

Installing the Slate 7
4. Insert the battery into the battery compartment.
5. Close the compartment door.
Recharging the Battery
The slate uses a rechargeable lithium polymer battery as the power source for mobile operation,
and a power adapter cable is included for recharging the battery or for powering the slate from an
external power source.
Before you use the slate for the first time, connect the power adapter cable and charge the battery.
You can continue with the installation and use the slate while the battery is charging. A new, fully
charged battery lasts for approximately 25 hours of constant use.
NOTE: The time required to fully recharge the battery varies depending upon factors such as the
battery’s charge and whether the slate is in use. If the battery charge is low, the battery takes
approximately five to six hours to fully recharge.
1. The power adapter cable has two parts, the adapter and the cable. If you haven’t already done
so, connect the adapter to the cable.
WARNING
Don’t recharge the battery with any power adapter other than the one supplied, as
this can cause damage to the slate and can cause a fire or personal injury.
If the slate becomes excessively warm or emits an unusual smell while the battery
is recharging, immediately disconnect the power adapter cable from the power
outlet and turn off the slate.
To recharge the battery
Battery
Battery
Battery