User's Guide
Table Of Contents
- Table of Contents
- Chapter 1. Introduction
- Chapter 2. Initial Activation of the Tag
- Chapter 3. Configuration After Initial Activation
- Chapter 4. Tag Operation
- 4.1. Button Activated Location Update and Maintenance Call
- 4.2. Safety Switch Activated Location Update
- 4.3. Working with the Display
- 4.4. Load Balance
- 4.5. Smart Roaming
- 4.6. Resetting to Factory Settings
- 4.7. Firmware Update
- 4.8. Optimizing Battery Life
- 4.9. Turning off the B4 Tag
- 4.10. Charging the B4 tag
- Chapter 5. Technical Specifications
- Chapter 6. Certifications
- Chapter 7. Limited Warranty
Figure 4.4. B4 tags in Multi Charger
The B4 tag is delivered with the battery charged to a storage charge, and it is recommended to
fully charge the batteries before first time activating the tag. To ensure the tag battery is full, please
put the tag in to a charger for 4 hours. To remove the charger plug, release the plug by pressing
the latches on the plug and pull the plug out.
The tag will give a notification when the tag battery is low. Connect the charger and the Right LED
will show orange light during the charging. after the tag is fully charged the Right LED will turn
green. If the tag battery is completely empty, the tag will automatically turn off. After a charger is
connected, the tag will automatically return to it's normal function, maintaining last settings.
The Ekahau supported adapters are
1. Ekahau C-T301B Charger
2. Ekahau C301B-10 Multi Charger
Note
In case the tag battery is completely empty, typically when left empty and uncharged for several
days, it may take a long time for the tag even to turn on the orange led. Just connect the charger
and leave the tag to recharge overnight.
Warning
Only use Ekahau supported adapters for charging the tags.
Warning
Recharge the tag only in room temperature conditions, 0 °C - 40°C (32 °F - 104 °F). Recharging
the tag in too cold or too hot conditions may damage the tag.
26
Chapter 4. Tag Operation