User's Guide
Table Of Contents
- Table of Contents
- Chapter 1. Introduction
- Chapter 2. Initial Activation of the Tag
- Chapter 3. Configuration After Initial Activation
- Chapter 4. Tag Operation
- 4.1. Button Activated Location Update and Maintenance Call
- 4.2. Safety Switch Activated Location Update
- 4.3. Working with the Display
- 4.4. Load Balance
- 4.5. Smart Roaming
- 4.6. Resetting to Factory Settings
- 4.7. Firmware Update
- 4.8. Optimizing Battery Life
- 4.9. Turning off the B4 Tag
- 4.10. Charging the B4 tag
- Chapter 5. Technical Specifications
- Chapter 6. Certifications
- Chapter 7. Limited Warranty
Default valueValuesDescriptionSetting
8553Port numberPort number of mainten-
ance protocol port of
ERC
Maintenance port (UDP)
100 - 63072000The interval of the peri-
odic maintenance calls
in seconds
Maintenance interval
Scan Settings
100 - 63072000The interval of the peri-
odic location scans in
seconds
Scanning Interval
1 - 11 Enabled; 12 - 14 DisabledEnabled; DisabledSets the channels that
are scanned
Scan Channels
WLAN Settings
defaultSSID=max 32 digitsSets the Wi-Fi network
name -Service set identi-
fier
SSID
No EncryptionNo Encryption; WEP
64/128; WPA2-PSK
Selects if WEP encryp-
tion is used
Encryption
-ASCII: 5 or 13 charac-
ters
HEX: 10 or 26 hexa-
decimal numbers (0-f)
Sets the WEP pass-
phrase
WEP
11 - 4Sets the WEP Key index
used
WEP Key Index
-8 - 63 ASCII charactersSets the WPA2-PSK
encryption and pass-
phrase
WPA2-PSK
Not supported in B4WPA-PSK
IP Settings
DHCPDHCP; StaticDefines the IP address
assigning method
IP method
Static IP Settings
0.0.0.0
0.0.0.0
IP addressSets the start and end
address of the range
used to assign the IP
addresses to the tags
when Static IP is used
Address range
0.0.0.0IP addressTag netmask when
static addressing is used
Network mask
0.0.0.0IP addressIP network gateway
when static addressing
is used
IP gateway
Chapter 2. Initial Activation of the Tag
15