User's Guide
Table Of Contents
- Table of Contents
- Chapter 1. Introduction
- Chapter 2. Initial Activation of the Tag
- Chapter 3. Configuration After Initial Activation
- Chapter 4. Tag Operation
- 4.1. Button Activated Location Update and Maintenance Call
- 4.2. Safety Switch Activated Location Update
- 4.3. Working with the Display
- 4.4. Load Balance
- 4.5. Smart Roaming
- 4.6. Resetting to Factory Settings
- 4.7. Firmware Update
- 4.8. Optimizing Battery Life
- 4.9. Turning off the B4 Tag
- 4.10. Charging the B4 tag
- Chapter 5. Technical Specifications
- Chapter 6. Certifications
- Chapter 7. Limited Warranty
Figure 2.9. Saving the configuration for later use
2.3.6 List of Available Settings in the Activator
The list of available settings in the Activator:
Default valueValuesDescriptionSetting
Positioning Engine settings
0.0.0.0IP AddressIP Address Ekahau
RTLS Controller
Engine IP
8552Port numberPort number of location
protocol port of ERC
Engine Port (UDP)
0.0.0.0IP AddressIP Address of Ekahau
RTLS Controller, from
where TAG gets the set-
tings. Typically same as
the ERC IP
Maintenance IP
14
Chapter 2. Initial Activation of the Tag