User's Guide
Table Of Contents
- Table of Contents
- Chapter 1. Introduction
- Chapter 2. Initial Activation of the Tag
- Chapter 3. Configuration After Initial Activation
- Chapter 4. Tag Operation
- 4.1. Button Activated Location Update and Maintenance Call
- 4.2. Safety Switch Activated Location Update
- 4.3. Working with the Display
- 4.4. Load Balance
- 4.5. Smart Roaming
- 4.6. Resetting to Factory Settings
- 4.7. Firmware Update
- 4.8. Optimizing Battery Life
- 4.9. Turning off the B4 Tag
- 4.10. Charging the B4 tag
- Chapter 5. Technical Specifications
- Chapter 6. Certifications
- Chapter 7. Limited Warranty
Figure 2.3. Specifying Wi-Fi network settings
Tip
If WEP encryption is used the Activator automatically determines the key type and length from
what you type. WEP 64 require 5 Ascii characters or 10 hex digits, respectively WEP 128
requires 13 Ascii characters or 26 hex digits.
2.3.3 Configuring Wi-Fi Channels in Use
It is recommended to only select the channels used in you network. Activating the unused channels
will only reduce the battery lifetime of the tag. By default, the Scan Interval is 60 seconds. You
may also use shorter interval, but it will drain faster the battery of the tag. Alternatively you can
use longer Scan Interval and enable Motion Sensor through the Ekahau RTLS Controller after
activation. This way the tag will scan only when it is in use and moving.
8
Chapter 2. Initial Activation of the Tag