Operation Manual

AIRIS POWER SERVER
User Manual Rev 1.0
54
Disk size will be shown in size field column as illustrated in Figure 3.8a
Figure 3.8a
After initializing to RAID 1 (Mirror), you should see a screen similar to Figure
3.8b where total size is the same as the original hard disk size. If the size of
Disk 1 and Disk 2 is different, then RAID 1’s total size would automatically
select the smaller one as its baseline. However, we suggest you to use the
same size when choosing RAID 1.
Figure 3.8b
After initializing to RAID 0 (Stripe), as shown in Figure 3.8c, you can see
that total size is the sum of two hard disks. Please be reminded that the
total size of RAID 0 would always be the sum of Disk 1 and Disk 2.
Figure 3.8c
In System Information page, when Powerful Server cannot detect hard drive
(Status of Disk 1 as illustrated in Figure 3.8d) or detect an error in S.M.A.R.T.
(Status of Disk 2 also illustrated in Figure 3.8d), you will see “Not Active”