Operation Manual

AIRIS POWER SERVER
User Manual Rev 1.0
11
Quick Installation
This chapter will give you brief instructions on how to install the product. In
section 2.1, we will configure the hardware part ofAIRIS Power Serverstep by
step. In section 2.2, we will check whether the IP address of your PC is
assigned by DHCP. Once we complete the installation of theAIRIS Power
Serverhardware and checked your PC settings, we will use the web-based
management to configure theAIRIS Power Serverto suit your network
environment. In section 2.3, and 2.4, we will review all the software settings.
We will configure it to gain access to the Internet. If you need additional help
or advanced setting details, please refer to the remaining chapters.
Hardware Installation
Please follow the steps below to install hardware:
1. Get the included Ethernet cable.
Connect one end of it to the ADSL/Cable modem and the other end
to the WAN port on the SA.
2. Get another Ethernet cable.
Connect one end of it to the PC or hub and the other end to one of
the LAN ports on the SA.
3. Turn the ADSL/Cable modem on. Note: Cable modem users MUST
disconnect the cable modem from the wall outlet for at least 2
minutes before turning it on again.
If there are more PCs or hubs to be connected, please repeat step
2.
4. Connect the included power adapter to the power socket on
theAIRIS Power Serverand then plug the power adapter into a wall
outlet.
5. Turn on the SA.
If the link LED of the WAN port is not ON, switch the WAN
MDI/MDIX switch to the alternate setting.
The hardware installation is now complete.