Quick Start Guide

Quick Start Guide – DFGT-03MCXXX

Airios Confidential and Proprietary Revision 15 – Draft Page 34 of 59

7 Time schedule

The DFGT features time schedule functionality to run a time program. It supports up to 42 switch points, which can

be flexibly configured over a period of one week (7 days).

7.1 Switch points

A switch point specifies the operating mode for the DFGT from a certain moment. A switch point can specify the

following parameters:

 The moment within the week it occurs (day, hour and minute)

 Control type (fixed flame height or temperature setpoint)

 Flame height or setpoint for temperature control

 State of the pilot

 State of the secondary burner

 State of the light*

 State of the boost fan*

 State of the wave

*Note: The state of the light and boost fan can only be ON or OFF.

7.2 Enabling

The time schedule can be enabled and disabled by the DFRC, BRDG or BLE device.

7.3 Temporary override

The time schedule can be temporary overridden by the DFRC, BRDG or BLE device by modifying the flame height,

burner state or temperature setpoint.

The temporary override is removed when the next switch point occurs or when the schedule is activated again (by

either DFRC, BRDG or BLE device).

7.4 Editing

The BRDG and BLE device can edit the time schedule in the DFGT. They can perform the following actions:

 Read a switch point

 Add a switch point

 Change a switch point

 Delete one switch point

 Delete all switch points

7.5 Availability

When person presence detection is configured, the time schedule functionality is disabled.

When there is no BRDG or BLE device and therefore the DFGT has no time schedule. The DFRC can have its

own time schedule that is ran by the DFRC. This can be configured through the settings.

When both DFGT and DFRC are configured to have a time schedule available, the DFGT time schedule has

priority and is available.

7.6 Settings

The following settings configure the availability of the time schedule in the DFGT.