Quick Start Guide

Quick Start Guide – DFGT-03MCXXX

Airios Confidential and Proprietary Revision 15 – Draft Page 21 of 59

Figure 12: LED blinking pattern according to blinking rate

For connecting external user interface: see Appendix A

4.3 Switch potentiometer (10k)

The potentiometer is used to set the required load (see Figure 13) and has to be connected to connector JP1. To

prevent the fireplace from being switched on automatically after a power-up, or a reset, the potentiometer must be

switched off first. Once the potentiometer has been switched off, the required load can be set again.

Figure 13: Relation between requested load and resistance of the potentiometer