Instructions / Assembly

REPLACING PRODUCT PARTS:
If a leak or problem is suspected with your tube, locate the valve and deflate the
item to inspect possible problem areas. Contact Sportsstuff warranty department
for prompt parts replacement if a problem is located. For non-warranty parts
replacement, follow the same procedure. When a replacement is received, remove
damaged portion and replace with new portion. Line up the valve and the valve
opening in the cover (where applicable) and repeat applicable steps in the ASSEMBLY
AND INSTALLATION section.
USE:
Once product is properly inflated this float can be used in pools or very calm
waters away from boats and other hazards.
INFLATION:
Your Sportsstuff product is equipped with the following type of valves:
Safety Valve – push-in valve used on safety chambers for use with
electric or hand pump. Affix the end of your inflator hose into the
small opening in valve. Make sure you open the small flap inside
the opening and inflate until firm. A small plastic straw is included
with tubes using this valve. This straw may temporarily be inserted
in the valve to keep the flap open while inflating and deflating.
Raised Speed Valve – for use with standard electric pump, shop
vac, wet vac, leaf blowers, vacuum with a 2-way switch for fast
inflation / deflation. An air compressor adapter is available directly
from Sportsstuff at www.sportsstuff.com or 888-814-8833.
Recessed Speed Valve – for use with standard electric pumps,
shop vac, wet vac, leaf blowers, vacuum with a 2-way switch for
fast inflation/deflation. An air compressor adapter is available
directly from Sportsstuff at www.sportsstuff.com or 888-814-8833.
Recessed Multi Valve – has a built-in air compressor adapter, for
use with standard electric pumps, shop vac, wet vac, leaf blowers,
vacuum with a 2-way switch or an air compressor for fast
inflation/deflation.
EZ Lock Valve - Sits flush with the tube bladder, with locking lid. for
use with standard electric pumps, shop vac, wet vac, leaf blowers,
or any vacuum with a 2-way switch for fast inflation/deflation.
Speed Safety Valve - A hybrid valve utilizing the best of both the
Oversized Safety Valve and the Speed Valve. Pulls out for fast infla-
tion/deflation, then can be pushed in flush with the tube. For use
with standard electric pumps, shop vac, wet vac, leaf blowers, and-
vacuums with a 2-way switch for fast inflation/deflation.
Proper inflation is the key to the optimum performance of this product. The PVC
bladder must expand and should be firm to the touch.
Secure the valve by firmly fastening the bottom portion of the valve into the base.
To inflate, open cap or top portion of the valve. Using the hose from your inflator,
54-1601SiestaLoungeManual.qxd 2/2/07 5:39 PM Page 3