User's Manual

F5D8230-4 user draft.doc Page 58 of 89
Set up the computer that is connected to the cable or DSL modem FIRST using
these steps. You can also use these steps to add computers to your Router after
the Router has been set up to connect to the Internet.
Manually Configuring Network Settings in Mac OS up to 9.x
1. Pull down the Apple menu. Select “Control Panels” and select “TCP/IP”.
2. You will see the TCP/IP control panel. Select “Ethernet Built-In” or “Ethernet” in the “Connect
via:” drop-down menu (1).
[xxxxxxx]
3. Next to “Configure” (2), if “Manually” is selected, your Router will need to be set up for a static
IP connection type. Write the address information in the table below. You will need to enter
this information into the Router.
[MacOS9 chart.tif]
(1)
(2)