User's Manual
Using the Console Port for CLI Access
Installation and Configuration Guide: Airgo Access Point 229
9 To see the list of available commands, type a question mark (?). For a list of hot keys (short cuts
for console functions, press Ctrl-H.
There are two important modes in console access, one is show mode and the other is config
mode. In show mode, examine the AP’s configuration settings and status. Use config mode to
change values. To go into either mode from the main command> prompt, type either show or
config.
Toggle between show and config modes by pressing Ctrl-P. Leave a mode and return to the top
level command prompt by typing exit.
To log out and close your connection to the command line interface, type logout at any prompt.