User's Manual
Configuring Wireless Security
Installation and Configuration Guide: Airgo Access Point 141
Figure 103: Security Services - SSID Auth
Assign the following values to configure SSID authentication:
Click Apply to save changes or Reset to return to previously saved values. It may be necessary to
click Back on your browser to return to the Security Configuration panel. Make sure to also click
Apply on the Security Configuration panel.
An external RADIUS server can also be added from this tab. Click Go at the bottom of the tab to
open the Authentication Zone tab of the Authentication Zones panel. For instructions on adding a
server, refer to “Configuring Authentication Zones” on page 143.
Feature Description
SSID Name Select from the SSID pull-down list. Click SSID Details to view more SSID-
related information, enable multiple SSIDs, or change other SSID attributes.
WPA Pre-Shared Key Enter the pre-shared key for WPA, if appropriate. This field is grayed out if
WPA-PSK is not the selected authentication type.
Authentication Server
Configuration
Select the Security Portal or External Authentication Server radio button. For
Security Portal, the IP addresses of all security portals are displayed below the
radio button. For External security, select from the list of RADIUS servers or
click Go at the bottom of the tab to configure the authentication server list
(see “Authentication Zones” on page 143). (required)
Enable MAC Access
Control List
Select to enable authentication using MAC addresses that are centrally
managed in a RADIUS server. For MAC-ACL authentication, it is necessary
to use a security portal or external RADIUS server.