User's Manual

Using the Network Topology Menu
Installation and Configuration Guide: Airgo Access Point 167
Figure 121: Network Topology - AP Enrollment - Enroll an AP Entry Panel
The Enroll an AP panel contains information that uniquely identifies the AP. To verify the identity
of the AP, compare the following information to the information on the paperwork shipped with the
AP:
When an AP is enrolled, it is configured with the enrolling AP’s bootstrap configuration. Refer to
Chapter 3, “Installing the Access Point,” for bootstrap configuration details.
Enrolled APs
Enrolled APs are listed on the Enrolled tab of the Enrollment panel (Figure 122). The screen should
refresh automatically to reflect new enrollments. If this does not happen, click Refresh.
Table 13: AP Enrollment Information
Field Description
AP Name Verify the alphanumeric name of the AP. The default is the IP address.
IP Address Verify IP address of the AP.
Serial Number Verify the AP serial number.
Thumbprint Verify the thumbprint, which uniquely identifies the AP for security purposes.
Password Enter and confirm the Airgo-supplied password.
Security Portal Indicate whether to use the AP as a standby security portal. With a backup
security portal, a copy of the user authentication database remains accessible
even if the NM Portal AP becomes unavailable.
NOTE: If DHCP is used for address assignment for enrolled Airgo APs, the AP
address may change periodically. When that occurs, there is no interruption to service,
and all security credentials remain intact.