User's Manual

7 Managing Security
140 Installation and Configuration Guide: Airgo Access Point
WEP Security
If it is necessary to configure WEP security, select Enable WEP to activate the WEP fields.
Configure the following values in the WEP security area:
Click Apply to save the settings or Reset to clear the fields on the panel.
Open Access
Select Enable Open Access to omit data encryption. A pop-up message warns of the potential
security risk in using open access. Click OK to continue.
SSID Authentication
Use the SSID Authentication tab (Figure 103) to assign RADIUS Authentication servers or a WPA
pre-shared key. RADIUS based authentication uses lists of servers, called authentication zones,
which are provided by the Airgo AP security portal or an external RADIUS server. Each SSID can
be configured with the RADIUS servers used for EAP authentication and the WPA pre-shared key
(if applicable).
MAC-ACL lookups can be enabled for clients that associate with WPA-PSK, manual WEP-keys,
or with no security. MAC-ACL is not applicable if per user authentication is done where user name
is available.
NOTE: Selecting WPA-EAP or WPA-PSK displays a link that leads to the SSID
Authentication tab. Refer to “SSID Authentication” on page 140 for instructions on
using this tab.
Field Description
Enable WEP Activate the WEP settings. The Airgo AP supports WEP with dynamic and
manually entered keys. To use dynamic keys, select WEP, but do not enter
values in the Key fields.
Key-Length Select 64-bit or 128-bit
Key 1 - Key 4 For manual keys, enter up to four WEP key values. Each WEP key is 26 hex-
ASCII characters. (required if security mode is WEP)