User's Manual

8 Configuring Guest Access
156 Installation and Configuration Guide: Airgo Access Point
Open Subnet
In an optional open subnet arrangement, shown in Figure 114, unauthenticated guest users are
permitted limited access to an open enterprise subnet specified in the Airgo AP. The enterprise
open subnet must be part of the Guest VLAN. Extended access requires authentication through an
internal or external landing page.
Figure 114: Guest Access - Open Subnet
Configuring Guest Access
This section describes the complete process of setting up guest access. A Guest Access wizard is
also available for easy configuration of the major guest access parameters. See “Guest Access
Wizard” on page 50 for instructions on using the Guest Access wizard.
Internet
VLAN Switch
Open Subnet
Open Subnet
Address Range
No Direct Internet Access
Until Authenticated
GUEST-VLAN
A0035B
Open Access
Server
User Group = "GUEST"
Task Steps
Confirm that open access
is supported as a security
option.
1 Choose Wireless Security from the Security Services menu to open the
Security Mode tab (“Configuring Wireless Security” on page 138).
2 Enable WPA security, if mixed mode security (encrypted and open) is
desired. Only WPA can be enabled in conjunction with open. The WPA
Security mode is for non-guests only.
3 Enable Open Access.
4 Click Apply.