User's Manual

C Alarms
258 Installation and Configuration Guide: Airgo Access Point
RADIUS server, as opposed to not receiving any response at all. The AP may have
attempted multiple retries or may even have switched to another RADIUS server
by this time. This indicates that due to higher latencies in the network, it might be
better to increase the timeout associated with the authentication server.
Usage: This indicates that the AP has determined that a RADIUS server has sent a late
response.
Examples: For device-id AP_00-0A-F5-00-01-89 , the RADIUS server 192.168.75.230:1812 sent a
late response - you might need to increase your RADIUS timeout of 4 seconds
See Also:
Security: STA authentication did not complete in time
Notification which indicates that the AP has determined that a station has failed to complete the
proper sequence of authentication exchanges in a timely manner.
Syntax: "For device-id %s, the STA %s[%d] on radio %d with user %s and SSID %s
did not complete its auth sequence in time with auth-type %d and enc-type
%d due to reason code %d"
Description: This notification is generated when the station authentication sequence did not
complete in time.
Alarm Parameters
DeviceId The Device ID of the Airgo AP
AP The MAC address of the upstream AP.
Station MAC address of the Station.
bpIndicator Identifies if the supplicant is a BP (1), or a STA (0).
Radio Identifies Radio by interface ID on the Access Point
User Supplicant User ID, if exchanged the during EAPOL authentication
SSID Identifies the SSID on this AP that the STA has associated with
Authentication Type The valid types include: LEGACY 802.1x (2), WPA PSK (3), WPA
EAP (4)
Encryption Type The valid types include: WEP-64 (1), WEP-128 (2), TKIP (5), AES
(6)
Reason Code The reason for the failure: EAP-REQUEST NOT RECEIVED FROM
AUTHENTICATION SERVER (2)
Alarm Severity
Severity Critical