User's Manual

C Alarms
256 Installation and Configuration Guide: Airgo Access Point
Security: STA failed to send EAPOL-Start
Notification which indicates that the STA has failed to send an EAPOL-Start even though it was
expected to for EAP based authentication.
Syntax: "For device-id %s, the STA %s on radio %d and SSID %s failed to send an
EAPOL-Start in order to begin auth of type %d"
Description: This notification is sent during authentication, when the Station fails to send an
EAPOL-Start in order to begin the authentication using WPA-EAP or legacy
802.1X protocols.
Usage: This indicates that the AP has determined that a STA has failed to send an EAPOL-
Start. This might indicate a misconfiguration on the STA. The AP expects the STA
to send an EAPOL-Start if the authentication type is deemed to be EAP based. This
can happen when WPA EAP authentication is negotiated, or when WEP is enabled
on the AP and no manual WEP keys are configured.
Examples: For device-id AP_00-0A-F5-00-01-89 , the STA 00:0a:f5:00:05:f0 on radio 0 and SSID
NewYorkRm failed to send an EAPOL-Start in order to begin auth of type 4
See Also:
Security: RADIUS sent a bad response
Notification which indicates that the AP has determined that a RADIUS server has sent a bad
response.
Syntax: "For device-id %s, the RADIUS server %s:%d sent back a bad response due
to %d"
Alarm Parameters
DeviceId The Device ID of the Airgo AP
Station MAC address of the Station.
Radio Identifies Radio by interface ID on the Access Point
SSID Identifies the SSID on this AP that the STA has associated with
Authentication Type The valid types include: LEGACY 8021.x (2), WPA EAP (4)
Alarm Severity
Severity Critical
Alarm Parameters
DeviceId The Device ID of the Airgo AP