User's Manual

4 Configuring Radio Settings
62 Installation and Configuration Guide: Airgo Access Point
Admin State Configuration
Use the Admin State tab (Figure 43) to assign the mode or persona of each radio interface.
Figure 43: Radio Configuration - Admin State
Set the following parameters on this tab:
Click Apply to save changes or Reset to return to previously saved values. Click Reset Radio to
Default to return the settings on all the radios to their factory defaults.
Feature Description
Select Radio Interface Select the AP radio (wlan0 or wlan1)
Admin State of Selected
Radio
Enable or disable the selected radio. When the AP radio is in the disabled
state, all valid configuration settings are saved. When the AP radio is enabled,
the latest configuration is applied. It is not possible to disable the BP radio by
administrative intervention. (AP radio only)
Persona of Selected
Radio
Select whether the AP radio is to operate as a normal AP (AP) or in backhaul
point mode (BP). Select Any to determine the radio mode automatically based
on network connectivity, configuration, number of radios, and presence of
Ethernet connectivity. It is recommended to accept the default setting of Any.
NOTE: Each access point can have at most one BP radio.