User's Manual

3 Using the Configuration Interfaces
40 Installation and Configuration Guide: Airgo Access Point
Click Apply to save changes in each section on the screen or Reset to return to previously saved
values.
Radio Config Tab
Use the Radio Config tab (Figure 27) to configure bootstrap parameters for the two AP radios.
DNS IP Address Enter the IP address of the server or servers supplying DNS service. This is
required if the IP address is not obtained automatically. The default is the
DNS server for the existing network.
Multiple DNS server addresses may be specified, space-separated. The AP
will use the addresses in the order specified. Manually configured DNS
addresses always take precedence over the DNS addresses returned by a
DHCP server. If the DNS IP Address field is empty, then all manually
configured DNS server addresses will be removed.
If you delete DNS servers, only those added manually are deleted. DHCP-
assigned DNS servers continue to be available.
Management IP
Address/Maskbits
Enter the IP address and subnet prefix for this AP. This is required if the IP
address is not obtained automatically. The default is 192.168.1.254/
24.
Gateway IP Address Enter the IP address of the gateway to the wired network. This is required if
the IP address is not obtained automatically. The default is the existing
network gateway.
Host Name Enter an alphanumeric name for the AP. The factory default for this field is
AP followed by the MAC address of the AP’s Ethernet interface (eth0).
AP Location Enter the physical location of the AP as a text string.
Administrator Contact Enter contact information for the person responsible for managing this AP
(phone or email address).
Field Description