User's Manual

3 Using the Configuration Interfaces
36 Installation and Configuration Guide: Airgo Access Point
6 After entering settings for both radios, click Finish to complete the initialization process. (If
initializing a portal AP, as described in the next section, the button is labeled Next.)
Initializing the Portal AP
Using the QuickStart panels to initialize NM Portal is similar to initializing a normal AP. The first
four panels, as described in the previous section, are the same as for the normal AP. When
configuring the second radio, click Next to set the administration and networking configuration
(Figure 22).
Figure 22: Portal QuickStart panel
7 Enter the following information consistent with your corporate standards:
8 Click Finish to complete the initialization process and bring up the AP Explorer Home panel.
The process takes approximately two minutes. When the process is complete, the Home panel
opens.
NOTE: The defaults for radio configuration have been selected for the best operational
radio behavior across a variety of environments. Modifying these parameters alters
radio behavior, which may have an impact on network performance or services. For
example, selecting an operating band of 5GHz (802.11a) may prevent legacy client
adapters from associating to the AP.
Field Description
Admin Password Enter and confirm the password used to manage this AP and other enrolled
APs. The password must be between 8 and 32 characters and is used for local
administrator login and SNMP v3 login. (required)
SMTP Server Name or
IP Address
Address of your SMTP server
Administrator Email
Address
Email address of the person to be notified regarding alerts