User's Manual

Using AP Quick Start to Initialize the Access Point
Installation and Configuration Guide: Airgo Access Point 35
4 Click Next after making selections.
The last two panels (Figure 21) configure each of up to two radios on the AP. After entering
settings on the first of the two panels, click Next to open the second panel.
Figure 21: QuickStart Radio Parameters
5 Set the following information:
Bootstrap Security
Mode
WPA-PSK, WEP-64, WEP-128, or Open security option. The option
determines the security mode for the AP.
WPA-PSK Security
Mode
Activated if WPA is selected as the security mode. Enter a alphanumeric
string at least eight characters in length. (required if security mode is WPA-
PSK).
WEP Key Activated if WEP is selected as the security mode. Enter a WEP key. A WEP-
64 key is 10 hex characters, and a WEP-128 key is 26 hex characters.
(required if security mode is WEP)
Field Description
Select Radio Interface Specific radio to be configured on the AP (wlan0 or wlan1). These correspond
to the WLAN0 and WLAN1 LEDs on the front of the AP.
Select Operating Band
and Mode
802.11b mode in the 2.4-GHz band, 802.11b or g mode in the 2.4-GHz band,
802.11a mode in the 5-GHz band, or auto selection (Any).
Configure Channel Select Auto-Select Channel or Assign Fixed Channel options:
• Auto-Select: Select At Start-up to automatically determine the channel
when the AP is booted, or Periodic to auto-select the channel at the
specified number of minutes.
• Assign Fixed Channel: Select a static channel.
In both of these cases, the channel set used for auto-scanning can also be
restricted.
Field Description