User's Manual

Installing the Access Point
Installation and Configuration Guide: Airgo Access Point 27
Figure 15: Airgo AP Connections
Using Power Over Ethernet
Power-over-Ethernet, based on the 802.3af standard, can be used to supply power to the Airgo AP.
If both DC power and power-over-Ethernet are used at the same time, then failover takes place
automatically in the event that one of the power sources is lost. For failover, the following rules
apply:
• The AP uses the power source with the highest voltage.
• Unplugging either cable causes power to switch automatically to the other source.
Placement and Orientation
Make sure that the Airgo AP is positioned in an upright position for airflow and antenna placement
(Figure 16).
100/10BaseT
Ethernet port
Default
Reset
A0003B
Console port
DC power