User's Manual

5 Configuring Networking Settings
120 Installation and Configuration Guide: Airgo Access Point
Figure 89: Filter Configuration - Filter Table
From the Filter Table tab, add a new filter by clicking Add, or edit an existing one by selecting the
filter and clicking Edit. The Add Filter Entry panel opens(Figure 90). Enter or select values for the
following fields:
Click Apply to save the values and return to the Summary tab. Click Cancel to return to the
Summary tab without saving the values.
Field Description
Interface Name If creating a new filter, select an interface from the pull-down list.
Filter Direction Specify whether the filter is for incoming (ingress) or outgoing (egress)
communications. It is necessary to create a separate filter for each.
Accept/Discard Indicate whether the filtering rule is to accept or discard the packet.
Select Match Indicate if the filter rule is satisfied when a packet contains an Ether Type
value that matches the specified Ether Type, or if the filter rule is satisfied
when a packet contains an Ether Type that does not match any other filter rule.
Ether Type is the standard Ethernet code for the type of packet (e.g., for IP,
the code is 2048, or 0x800 hex).