User's Manual

5 Configuring Networking Settings
108 Installation and Configuration Guide: Airgo Access Point
accordingly. The Interface VLAN tab (Figure 78) specifies treatment of frames that arrive at the AP
in an untagged state. Each interface is assigned to a VLAN, which then receives all untagged
frames arriving at the interface.
Figure 78: VLAN Configuration - Interface VLAN
Make sure that the VLAN is defined before assigning an interface, and then configure the following
fields:
Click Add to assign the interface to the specified VLAN.
User VLAN
The read-only User VLAN tab (Figure 79) lists the client stations mapped to each VLAN by way of
bound service profiles. The tab contains the following information:
See “Configuring SSID Parameters” on page 78 for information on service profiles.
Field Description
Select Interface Select the AP interface.
VLAN ID Enter the VLAN ID. (required)
Default Select to assign this as the default VLAN for untagged frames.
Field Description
VLAN ID VLAN identifier
VLAN name Alphanumeric name of the VLAN
IP Address Address used to access the VLAN
MAC Address MAC addresses of the client stations that are mapped to this VLAN through
their user group’s service profile