User's Manual

5 Configuring Networking Settings
102 Installation and Configuration Guide: Airgo Access Point
The default setting for STP is enabled. Disable STP if the network is small to mid-size and
looping is not a concern.
Bridge Statistics
The Bridge Stats tab (Figure 72) provides a summary of transmit/receive statistics for each bridge
or VLAN. The statistics are calculated from the last time the AP was rebooted or the Clear
Statistics button was selected. Click Clear Statistics to return the collected values to zero and start
collecting statistics again.
Figure 72: Bridge Configuration - Bridge Stats
ARP Table
The Address Resolution Protocol (ARP) tab (Figure 73) displays the current mapping of IP
addresses to MAC addresses associated with the listed interface. During normal operations, the
ARP table is updated automatically based on the number of MAC entities in the network. If a
mapping changes, however, some entries of the ARP table may become invalid. In this case, click
Clear ARP Cache on the tab to remove the current ARP entries and repopulate the table
automatically with valid entries. Click Refresh to update the display.