User's Manual

4 Configuring Radio Settings
90 Installation and Configuration Guide: Airgo Access Point
Select a station from the Station Associations table and click Security-Stats to display the
following information:
Configuring Inter Access Point Protocol (IAPP)
Inter-Access Point Protocol enables neighboring access points to keep up-to-date information
concerning the status of roaming client stations. Select IAPP Configuration from the Wireless
Services menu to configure the IAPP settings and to view the associated topology and statistics.
The panel contains the following tabs:
• IAPP Service—Enable or disable IAPP.
• Topology—View BSSID, IP address, and compatibility details.
• Stats—View statistics details, including notifications sent and received, “move” notification
and response details, and details on Intra-AP moves.
Field Description
Station MAC address The MAC address that identifies the station
Auth Type Authentication used by station (Open, Shared key, EAP or MAC-ACL)
Encryption Encryption used by station (AES, TKIP, WEP, or open access)
AES Transmitted
Blocks
Number of AES transmitted blocks. Valid only if encryption is AES
AES Received blocks Number of AES received blocks. Valid only if encryption is AES
AES Replays Number of AES replays. Valid only if encryption is AES
AES Decrypt Errors Number of AES decryption errors. Valid only if encryption is AES
WEP Excluded Count Number of WEP exclude packets Valid only if encryption is WEP
WEP Undecryptable
Count
Number of times frames were not encrypted or a frame was discarded due to
the receiving station not implementing the privacy option. (Valid only if
encryption is WEP.)