User's Manual

8 Configuring Guest Access
176 Installation and User Guide: Airgo Access Point
Perform the following functions from the Guest Table:
Figure 124: Guest Access Configuration - Add Guest to SSID
Guest Access Security
The Security tab of the Guest Access Configuration panel (Figure 125) provides an interface to set
the guest password for an internal landing page.
Function Description
Add an entry to the
Guest Table
One guest profile can be added for each SSID. If a profile is already assigned
to an SSID and you add a new one, it replaces the previously defined profile.
1 Click Add to open the Add Guest to SSID entry panel (Figure 124).
2 Select the SSID.
3 Select the service profile from the Profile pull-down list. The profile
details are listed at the bottom of the entry panel.
4 If desired, enter the address and maskbits for a subnet optionally reserved
for unauthenticated guest access (A.B.C.D/maskbits format)
5 Select an internal or external landing page. If the external page is selected,
enter the full IP-based URL and the shared secret code used for
communicating with the RADIUS server.
6 Click Apply.
Modify an entry 1 Select the entry you wish to modify, and click Modify.
2 Confirm the SSID.
3 Select the service profile from the Profile pull-down list.
4 If desired, enter the address and maskbits for a subnet optionally reserved
for unauthenticated guest access.
5 Select an internal or external landing page. If the external page is selected,
enter the full URL and shared secret code for access.
Click Apply.
Delete an entry 6 Select the entry and click Delete.
7 Click OK to confirm.