User's Manual
D Alarms
314 Installation and User Guide: Airgo Access Point
E
xamp
l
es
For device-id AP_00-0A-F5-00-01-89 , the STA 00:0a:f5:00:05:f0 [0] on radio 0
and SSID NewYorkRm did not send its user-id in time to complete its auth
sequence with auth-type 4 and enc-type 6
S
ee
Al
so
EAP Response Timeout, STA Authentication Timeout
Security: EAP response timeout
Notification that indicates the STA has failed to respond in a timely manner with an EAP response
during the authentication exchange
S
yntax
"For device-id %s, the STA %s[%d] on radio %d with user %s and SSID %s did not
send an EAP-Response in time to complete its auth sequence with auth-type %d
and enc-type %d"
D
escr
i
p
ti
on
This notification is generated when an STA fails to send an EAP response in time to complete
its authentication sequence using the specified authentication type and encryption. This is an
EAP response other that the User-ID.
U
sage
G
u
id
e
li
nes
This indicates the failure of a STA to complete its EAP authentication exchange in a timely
fashion.The two authentication modes that require the STA to send EAP responses are WPA
EAP and legacy 8021.x for dynamic WEP. This trap might indicate that a user prompt is not
attended to on the client side. It may also indicate that the client silently rejected a EAP request
Alarm Parameters
DeviceId The device ID of the Airgo AP
Station The MAC address of the station
bpIndicator BP (1) or STA (0) supplicant
Radio Radio interface on the AP
User Supplicant user ID established during EAPOL Authentication
exchange
SSID SSID on the AP to which the station has associated.
Authentication type LEGACY 802.1x (2) or WPA EAP (4)
Encryption Type WEP-64 (1), WEP-128 (2), TKIP (5), or AES (6)
Alarm Severity
Severity Critical