User's Manual

D Alarms
302 Installation and User Guide: Airgo Access Point
E
xamp
l
es
For device-id AP_00-0A-F5-00-01-89 , the RADIUS server 192.168.75.230:1812
sent a late response - you might need to increase your RADIUS timeout of 4
seconds
S
ee
Al
so
Security: STA authentication did not complete in time
Notification that indicates the AP has determined that a station has failed to complete the proper
sequence of authentication exchanges in a timely manner
S
yntax
"For device-id %s, the STA %s[%d] on radio %d with user %s and SSID %s did not
complete its auth sequence in time with auth-type %d and enc-type %d due to
reason code %d"
D
escr
i
p
ti
on
This notification is generated when the station authentication sequence did not complete in
time.
U
sage
G
u
id
e
li
nes
This indicates that the AP has determined the station authentication sequence did not complete
in time.
Alarm Parameters
DeviceId The device ID of the Airgo AP
AP The MAC address of the upstream AP
Station The MAC address of the station
bpIndicator BP (1) or a STA (0) supplicant
Radio Radio interface on the AP
User Supplicant User ID, if exchanged the during EAPOL authentication
SSID SSID on the AP to which the station has associated
Authentication Type LEGACY 802.1x (2), WPA PSK (3), or WPA EAP (4)
Encryption Type WEP-64 (1), WEP-128 (2), TKIP (5), or AES (6)
Reason Code The reason for the failure: EAP-REQUEST NOT RECEIVED FROM
AUTHENTICATION SERVER (2)
Alarm Severity
Severity Critical