User's Manual

Configuring Radio Parameters
Installation and User Guide: Airgo Access Point 61
• Channel Configuration — Configure channel usage for each radio.
• Performance and QoS — Configure enhanced data rates, performance attributes, and Wi-Fi
Multimedia (WMM) quality of service support.
• Admission — Specify categories of client stations permitted to associate to the selected radio.
To configure settings on these tabs, select each in sequence, or step through using the Go links at
the bottom of the panel (shown in Figure 42).
Many of the radio parameters are interdependent, and the Airgo AP performs consistency checks
during configuration to prevent user actions from adversely affecting radio performance. This is
especially true of dual radio APs, due to the proximity of the two radios. If you attempt to make
configuration changes that are not accepted by the AP, an error message may or may not appear.
Consult the appropriate section in this chapter to determine which parameters are in conflict.
Global Configuration
Use the Global Configuration tab (Figure 42) to define settings that apply to all configured Airgo
AP radios.
Figure 42: Radio Configuration - Global Config
NOTE: All the settings on this tab are optional. If the AP radio is enabled when the
global configuration is changed, then it is necessary to reset the AP for the changes to
take effect. If the radio is disabled, the changes take effect once the radio is enabled.