User's Manual

3 Installing the Access Point Using the Configuration Interfaces
44 Installation and User Guide: Airgo Access Point
Figure 27: AP Quick Start - Bootstrap Configuration - Radio Config
This tab contains the following settings:
For further information regarding these settings, see Chapter 4, “Configuring Radio Settings.”
Field Description
Radio Admin State Select each AP radio (wlan0 or wlan1) to enable or disable.
Network Connectivity Indicate whether the radio will be used in a normal AP connected to the wired
network (Wired-Only), for wireless backhaul (Wireless-Only), or may be used
for either (Any). If Any is specified, the system will automatically choose
wired when an Ethernet connection is available and wireless if an Ethernet
connection is not present.
Network Density Indicate the relative concentration of APs in the network. For closely spaced
APs that can support high data rates, select the high density option. For
maximum coverage at lower data rates, select the low density option. The
default setting is Low.
Multi Domain Support Enable or disable 802.11d operation. If Enable is selected, the radio advertises
country, channel, and associated maximum transmit power information in
beacons and probe responses to stations or clients in the BSS. The default
setting is enabled.
World Mode - Country
Code
Select Default to set the channel and power for the radio to the factory default
country setting (U.S.). Alternatively, select a country code from the pull-down
list.
Deployment
Environment
Specify the type of environment in which the AP is installed (indoor, outdoor,
or both). The Environment setting determines the maximum transmit power
and allowed channels of operation. The default is Any.