User's Manual

Using AP Quick Start to Initialize the Access Point
Installation and User Guide: Airgo Access Point 37
4 Click Next after making selections.
The last two panels (Figure 21) configure up to two radios on the AP. After entering settings on
the first of the two panels, click Next to open the second panel.
Figure 21: QuickStart Radio Parameters
5 Set the following information:
Network Density Indicates the proximity of APs to each other. For closely spaced APs that can
support high data rates, select the high density option. For maximum coverage
at lower data rates, select the low density option. The default setting is Low.
Bootstrap Security
Mode
WPA-PSK, WEP-64, WEP-128, or Open security option. The option
determines the security mode for the AP.
WPA-PSK Security
Mode
Activated if WPA is selected as the security mode. Enter a alphanumeric
string at least eight characters in length. (required if security mode is WPA-
PSK)
WEP Key Activated if WEP is selected as the security mode. Enter a WEP key. A WEP-
64 key is 10 hex characters, and a WEP-128 key is 26 hex characters.
(required if security mode is WEP)
Field Description
Select Radio Interface Specific radio to be configured on the AP (wlan0 or wlan1). These correspond
to the WLAN0 and WLAN1 LEDs on the front of the AP.
Select Operating Band
& Mode
802.11b mode in the 2.4GHz band, 802.11b or g mode in the 2.4GHz band,
802.11a mode in the 5GHz band, or auto selection (Any).
Field Description