User's Manual

Using AP Quick Start to Initialize the Access Point
Installation and User Guide: Airgo Access Point 35
• Monitoring of Airgo Networks network for faults, configuration alerts, performance, and
security (FCAPS)
• Upgrade of the Airgo AP network with new software images
Initializing a Normal AP
1 Click Bootstrap Normal AP from the Quick Start Welcome panel to open the first
initialization panel (Figure 19).
Figure 19: QuickStart Configuration Parameters
The following fields are available on this panel; however, it is not necessary to reset any of
these fields to initialize the AP:
NOTE: Click Logout if it is necessary to leave the Quick Start panels. If you log out
prior to completing the setup process, the settings are not saved.
Field Description
AP Hostname Alphanumeric name for the AP. The factory default for this field is AP
followed by the MAC address of the AP’s Ethernet interface (eth0).
Enable DHCP Assigned
IP Address
Checkbox that indicates whether DHCP is used to obtain an IP address. If the
box is cleared, the static Management IP Address fields are activated; if the
box is selected, the static Management IP Address fields are inactive.