User's Manual

Ping Test
Installation and User Guide: Airgo Access Point 131
Figure 94: SNMP Configuration
Enter values in the following fields to define the basic SNMP configuration:
Click Apply to save your changes, or Reset to return to previously saved values.
The bottom of the SNMP panel contains a table of currently defined traps. To delete a trap, select it
in the SNMP Agent Table, and click Delete.
Ping Test
Use the Ping Test panel to execute an ICMP Echo Request to check network connectivity to a
remote IP host. Enter the hostname or IP address of the remote host. Figure 95 shows the Ping Test
panel with test results presented.
Field Description
Community String Enter the alphanumeric community string. (required)
Community Read/Write
Status
Indicate the read or read/write status of the community.
Trap Sink IP Address Enter the IP address where SNMP traps should be sent. (required)
Trap Community Enter the community for SNMP traps.
Trap Sink Port Indicate the port identified for the SNMP traps. (default is 162)