User's Manual

5 Configuring Networking Settings
128 Installation and User Guide: Airgo Access Point
Figure 90: Filter Configuration - Add Filter Entry Panel
Filter Statistics
The Filter Stats tab (Figure 91) lists statistics for each defined filter. The statistics are calculated
from the last time the AP was rebooted or the Clear Statistics button was selected. The Hits column
shows the number of packets of the specified type received on the interface with the defined filter.
Click Refresh to update the statistics or Clear Statistics to return the collected values to zero and
start collecting statistics again.
Figure 91: Filter Configuration - Stats Tab
Configuring Interfaces
Use the Interface Configuration panel, accessible from the Networking Services menu, to configure
the physical AP interfaces (wlan0, wlan1, eth0). The panel contains the following tabs:
• IF Table — View the administrative and operation state of each of the interfaces, and bind an
IP address to each interface.
• IF Stats — View the packet and byte statistics for traffic traversing each interface.