User's Manual

5 Configuring Networking Settings
114 Installation and User Guide: Airgo Access Point
Interface VLAN
When the AP receives a frame, it must determine the VLAN to which the frame belongs. If the
received frame is tagged, then VLAN is already known and the AP can route the packet
accordingly. The Interface VLAN tab (Figure 78) specifies treatment of frames that arrive at the AP
in an untagged state. Each interface is assigned to a VLAN, which then receives all untagged
frames arriving at the interface.
Figure 78: VLAN Configuration - Interface VLAN
Make sure that the VLAN is defined before assigning an interface, and then configure the following
fields:
Click Add to assign the interface to the specified VLAN.
User VLAN
The read-only User VLAN tab (Figure 79) lists the client stations mapped to each VLAN by way of
bound service profiles. The tab contains the following information:
NOTE: Do not add the wlan0 or wlan1 radio interfaces to the management
VLAN.
Field Description
Select Interface Select the AP interface. (required)
VLAN ID Enter the VLAN ID. (required)
Default Select to assign this as the default VLAN for untagged frames.
Field Description
VLAN ID VLAN identifier