Operation Manual
WARNING: ALWAYS KEEP THE MUZZLE
POINTED IN A SAFE DIRECTION
WARNING: Before loading your airgun, make sure the safety is in the On
Safe position and the muzzle is pointed in a safe direction.
Loading, Cocking, Firing
WARNING: Do not move the safety to the On Fire position unless the air
gun is pointed in a safe direction. Safe means that if the gun discharged it would
not cause injury or property damage. Mechanical safeties are not infallible and do
not replace the need for responsible gun handling practices.
Manually move the safety to the On Safe position by sliding safety lever back
towards trigger.
After loading, pull the charging
handle towards the rear of the gun,
and push it in towards the frame,
until the levers touch the side plate
and magnet. This closes the breech
and cocks the striker.
To re, take aim, slide the safety to
the On Fire position and squeeze the
trigger until the rie discharges.
Breech
Loading Tray
Side Plate & Magnet
Charging Handle
Bolt
Bolt/Charging Handle
closed position
Bolt/Charging Handle
open position
Safety Lever
On Safe Position
Safety Lever
On Fire Position
To load the rie, pull the
charging handle away
from the frame and push
it toward the muzzle until
it cannot open any further.
Place a pellet in the loading
tray and push it into the
breech, with your thumb or
a pellet seating tool, until
it engages the riing. This
is important for accuracy,
because it makes each shot
start from the same place.
Set Screw