Operation Manual
NOTICE: READ THIS MANUAL ENTIRELY BEFORE
CHARGING OR USING YOUR AIRGUN
WARNING: Make sure air rie is unloaded before installing or
removing Spin-Loc Sleeve.
CAUTION: Frame must be equipped with Spin-Loc system to install
Spin-Loc tanks.
Figure 1
Figure 2
Slide the air tank into
the rear of the frame.
See FIGURE 1.
Screw the Spin-Loc
Sleeve onto the air tank
until it is hand tight.
Make sure that the Set
Screw is loose and
allows the Spin-Loc
Sleeve to turn freely.
See FIGURE 2.
Use the Spin-Loc
Wrench to tighten the
air tank in place. Use
CARE so you will not
scratch your aluminum
Frame. See FIGURE 2.
Figure 3
To rell your Spin-Loc Tank, attach
the 3000 p.s.i. rated quick disconnect
to the rell tting. See FIGURE 3.
Filling/Attaching the Air Tank
Spin-Loc™ Tank System
Figure 2
NOTE: If you have a Quick-Detach
Air Tank, without the gauge and
rell tting, tighten the set screw
to keep the Spin-Lock Sleeve from
turning. Then screw in your Quick-
Detach Tank as you normally do in a
standard frame.