Specifications

www.ripmax.com
Distributed to all good model shops by: See the full Ripmax range at www.ripmax.com
P-WRT-7 Futaba Wireless Trainer System .................. £99.99
P-JEEXPE4
Jeti Expander E4 ......................£39.99
The Jeti Expander E4 allows you to
connect more than one sensor to be
attached to a duplex receiver (up to
four sensors).
P-JESMAXBEC2 Jeti Max BEC 2 ....................................................................................£71.99
Max BEC 2 is a linear voltage stabiliser with an adjustable output voltage.
The output voltage is set using a jumper and in one of four positions: 5.0V,
5.4V, 5.7V or 6.0V. Max BEC 2 can be powered using NiXX and Li-XX cells.
Max BEC 2 also gives an indication of used capacity of the battery with four
LEDs.
Wireless Trainer System.
The no strings attached way to learn to fly!
•
Does away with trainer cords and leads, allowing the instructor and student to stand up to 30ft apart
•
Plugs into the trainer port of any instructor’s transmitter which has the micro connector trainer port
•
FASST, or conventional FM-PPM, PCM 1024 or PCMG3 (Student Tx must be FASST system)
•
Easily programs through the transmitter
•
Suitable for simulator use (additional lead required)
O-IPLBM Pro-Peak Battery Monitor - Li-Po/Li-Fe ...........£6.99
Quick to use and small enough to store easily,
this simple LED display unit can measure
individual cell and total pack voltage of any Lithium technology battery
up to 6S. The unit cycles across the individual voltages and then the
total voltage in turn.
The small size and low weight means that you can mount it in the model
or use as a hand held unit.
Weighs Only 5.8g
Lightweight and Portable
O-IPLCM Pro-Peak Cell Master ......................................... £39.99
The Pro-Peak Cell Master balance/discharger is designed
for Li-Po and Li-Fe batteries. It can measure battery voltage
precisely and balance each cell’s voltage in a battery pack.
You can observe each cell’s voltage in the battery pack
individually. This helps identify abnormal or failing cells
during the charging or discharging process. The balance
function can be executed before or after the battery has been
charged. It also can be done during the battery charging
process, helping to ensure that the battery pack remains in
excellent condition.
•
Easy to Operate
•
Adaptor Board Included
•
2~6 Cell Operation
Helps Maintain
Battery Performance
Crystal Clear LCD Display