Specifications

www.ripmax.com
Distributed to all good model shops by: See the full Ripmax range at www.ripmax.com
27
Weight: 16.8g Channels: 2
Dimensions: 46 x 31.5 x 25mm
Weight: 13.5g Channels: 8
Dimensions: 45 x 22 x 13mm
Weight: 21g Channels: 14
Dimensions: 52.5 x 37.5 x 16mm
Weight: 8g Channels: 3
Dimensions: 39 x 26 x 10mm
Weight: 6.7g Channels: 6
Dimensions: 21.7 x 38.8 x 12.3mm
Weight: 7.1g Channels: 6
Dimensions: 21.7 x 38.8 x 12.3mm
Weight: N/A Channels: N/A
Dimensions: 400mm Length
A pair of low cost AM two channel receivers that incorporate a single chip design for improved
reliability and new moulded cases with crystal protection. The 27MHz version is Ideal for use in
model cars, boats and simple aircraft and the 40MHz ideal for all surface vehicles.
New from Futaba is this micro 4 channel
receiver designed specifically for indoor and
park flying. Weighing only 3.9 grams this is the
lightest receiver Futaba have ever produced,
and using FASST technology and with throttle
failsafe it is also extremely reliable.
This 8ch receiver from Futaba differs from all
previous receivers because it can run on 2
modes. There is a “Normal Mode” where the
receiver works like all previous Futaba 2.4
GHz receivers but there is also a “High Speed”
setting with high resolution for the demanding
modeller.
The R6014HS is the only 14 channel 2.4GHz
receiver in the world, being suitable for even
the largest and most sophisticated models,
yet weighing a mere 21 grams. Aimed at the
advanced pilot, and developed alongside the
matching FTM-14 module for the 12FG/12Z/
14MZ and FX40 transmitters.
This 6 channel
receiver is recommended for Parkflight aircraft
with a wingspan of up to 1300mm and electric
powered helicopters with a rotor diameter of
up to around 1000mm. Operating range is
approximately 300m.
Sharing the attributes of the R6106HF receiver,
the R6106HFC receiver benefits from a longer
coaxial aerial, making it suitable for use in
models with carbon fuselages as the longer
aerial can be positioned externally.
This is the New R603GF Receiver that uses
Futaba’s FHSS (Frequency Hopping Spread
Spectrum) Technology and is for use with
the T2PL 2.4GHz Transmitter. The R603GF
receiver has a flexible coaxial antenna that
is easy to position inside the model for ideal
reception.
Extended 400 mm
receiver aerials for 2.4 GHz FASST aircraft/
helicopter receivers, which allows the receiver
aerials to be deployed outside the fuselage in
models with all-carbon canopies or fuselages.
These aerials are also ideal for use in jet models.
With care the aerials can be exchanged for the
standard aerials by any experienced user.
P-R162JE/27 2ch Rx BEC AM27 ........................................................................... £19.99
P-R162JE/40 2ch Rx BEC AM40 ........................................................................... £19.99
Weight: 3.9g Channels: 4
Dimensions: 35 x 20 x 7mm
P-R6004FF/2-4G
4ch Rx 2.4GHz Indoor/Parkfly ...........£54.99
P-R6008HS/2-4G
8ch Rx 2.4GHz (FS/HS Mode) .........£124.99
P-R6014HS/2-4G
14ch Rx 2.4GHz (FS/HS Mode) .......£179.99
P-R603GF/2-4G
3ch Rx 2.4GHz (for 2PL only) .......... £64.99
P-R6106HF/2-4G
6ch Rx 2.4GHz Indoor/Parkfly ..........£64.99
P-R6106HFC/2-4G
6ch Rx 2.4GHz (Coaxial Ant.) ...........£64.99
P-RA2-4G/400
2.4GHz 400mm Extended Rx Aerial-Pr ... £14.99