Specifications

IT IS IMPORTANT TO USE ONLY CLEAN AND DRY COMPRESSED AIR

TO CLEAN THE FILTERS, OTHERWISE CONTAMINATION TO CARTRIDGE

FILTER ELEMENT WILL RESULT. DO NOT HOOK UP TO A COMPRESSED

AIR LINE THAT HAS AN AUTOMATIC OILING DEVICE ON IT. OIL OR

WATER WILL MAKE CLEANING DIFFICULT AND SHORTEN THE FILTER

LIFE.

NOTE

Not all applications will self-clean. Sticky or oily dust may not dislodge from the filter. In this case, the

filters must be cleaned or replaced.

HEPA FILTER:

(On models equipped with optional external module) cannot be cleaned. See your distributor for replacement.

AD MODULE:

(On models equipped with optional external module.) The adsorption material

(activated carbon or other) can be emptied from the module and refilled with

fresh adsorber. Refer to the Figure 13. Use the large opening to fill the majority

of the module. After as much material can be put in as possible, use the small filler

hole on the end to top off module. It is important to get the AD module as full as

possible as any low spots or air gaps will allow the gas being captured to by-pass

or be exposed to a reduced amount of scrubbing. Always dispose of the spent

adsorption material in accordance with local, state and federal

regulations.

The module is refillable as follows:

1. Remove module and take to a well ventilated area:

DUST IS RELEASED DURING THE

REFILLING OPERATION.

2. Remove cover plate and empty contents of module into a plastic bag or other approved container.

WEAR ADEQUATE PERSONAL PROTECTIVE DEVICES.

Figure 13.