INSTRUCTION MANUAL Bar Cooler (Available in single, 2-Door and 3-Door)
IMPORTANT SAFETY INSTRUCTIONS Before switching on your Bar Cooler for the first time, read the information in this Users’ Manual carefully. Keep this booklet in a safe place for future reference. If you ever sell you appliance, hand this manual to the new owner. The manufacturer does not accept responsibility for any damages that may arise from failure to follow the instructions in this manual. · Do not use damaged appliances. If you are in any doubt, consult an authorized service center agent.
above 30°C. The refrigerator meets the operating conditions according to the standard EN 441-4 in climate class 4. A 10A fuse is fitted. Never replace with a fuse rated higher than this. · Do not allow children to play with the appliance or to sit on it or to hang onto the door. · Make sure there is a suitable power outlet (230 volts, 13 amps outlet) with proper grounding to power the refrigerator. · Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
OPERATION · Place the shelves firmly on their supports. Check that the refrigerator is functioning properly before installing and filling it. An optional light switch is inside the unit. · Never put warm or hot food directly into the Bar Cooler. There are several types of controller/thermostat for different models. Please check which type of controller is on your unit. ELECTRONIC THERMOSTAT · During normal operation, the controller display will show the temperature inside the refrigerator.
To manually activate “Defrost” cycle: · Press the button and hold it for 6 seconds until a “beep” can be heard. · The indicator light will now illuminate under the “Defrost” symbol and the fridge is into a “Defrost” cycle. · “Defrost” will run for 20 minutes and then automatically revert to normal operation. To manually change back to normal operating mode from the “Defrost” mode: · Press the button again. Hold the button for 6 seconds until a “beep” is heard.
IMPORTANT · The fridge will go through a normal periodical defrosting cycle and a manual defrosting operation is only required in most extreme cases. It is better to avoid if not necessary. · While in the “Defrost” mode, the fridge cooling power is reduced as the compressor is not working. The automatic cycles ensure the defrosting is done in the most efficient manner and when required. It is not recommended to leave the fridge in the manually set Defrost mode for prolonged periods of time though.
· Do not allow the control panel, cables or plug to get wet. · Never use corrosive detergents, wire brushes or abrasive scourers to clean your Bar Cooler. Also, never use metal or sharp implements to remove debris / dirt. · Dry all surface thoroughly. · To ensure a trouble-free operation, the condenser should be cleaned every three months, where appropriate, using a vacuum hose. The condenser is located behind the lower grill of the cabinet.
