Install Guide

3/18/03 Step 5: Verifying 802.11a Operation 12

Step 5: Verifying 802.11a Operation

You have added 802.11a functionality to a 1200B Airespace AP. Perform the

following to verify correct 802.11a operation.

• Enable the Site Survey function by placing the factory-supplied jumper

across both of the Site Survey header pins on the Airespace AP mother-

board as shown in the following figure.

Figure - 802.11a Site Survey Jumper in the Airespace AP

• Put the door back on the Airespace AP case, and use one of the door

screws to temporarily hold the door closed while you apply power to the

Airespace AP.

• Use either an Airespace AP External Power Converter, or a connection

from an 802.3af-compliant Power Over Ethernet device to power up the

Airespace AP.

The red Fault LED should light for about one minute, and then the AP

should begin an up-and-down LED flashing sequence, indicating that

the Airespace AP is receiving power, is not talking to an Airespace