User's Manual
Table Of Contents
- Airespace Access Point (AP) Installation Guide
- Trademarks and Service Marks
- FCC Statements for Airespace AP
- About this Guide
- About the Airespace Access Point
- About Airespace AP Models
- About Airespace AP 802.11a Radio Cards
- About Airespace AP External and Internal Antennas
- About Airespace AP LEDs
- About Airespace AP Connectors
- About Airespace AP Power Requirements
- About Airespace AP External Power Converter
- About Power Over Ethernet
- About Airespace AP Mounting Options
- About Airespace AP Physical Security
- Airespace Access Point Quick Installation Guide
4/21/03 Projection Wall Mount
90-100xxx-000 Airespace Access Point Quick Installation Guide 9
Projection Wall Mount
Projection Wall Mount
When you are mounting the AP out from a wall (flat sides along the wall or
hallway), use the projection-mount L-bracket.
• Before proceeding, gently screw the two factory-supplied screws and
spring washers into the bottom of the Airespace AP. Make sure the
spring washers have their convex (high center sections) pointing
toward the screw heads.
Note: The Airspace AP threaded holes have precision-depth threads. Do
not overtighten the screws, or the bracket will not fit under the screw
heads.
Figure - Assembling the Mounting Screws and Spring Washers to the Airespace AP
• Copy the MAC address(es) from the label(s) on the AP onto the corre-
sponding location on the map. MAC addresses have the format
000B85xxxxxx.
• You have already attached the projection-mount L-bracket to the wall
in Step 2: Preparing Mounting Locations
.
Slide the screws into the keyhole slots on the mounting bracket as
shown in the following figure.
Note: If the screws do not securely hold the bracket, remove the AP
and adjust the screws until they securely hold the bracket.